1. Flooring floor radiant heating is any smooth and dry ground.
To mount the system to vacate the premises from the furniture and remove the old flooring. If necessary, align concrete screed floor surface. Mark the location of permanent furniture. Prepare a place in the LUX thermostat, a supply of electrical and conclusions of radiant heating sections
2. Laid a layer of insulation (natural cork).
Put on the part of the floor to be radiant heating, thermal insulation (expanded polystyrene, foam, cork boards, etc.), securing it with tape (Fig. 2). Above the insulation is placed concrete screed thickness of about 1 cm so that the cable does not touch insulation because it can cause overheating of the cable in and out of the appliance. If, under your floor is warm, then for comfortable floor radiant heating insulation can not install
3. Plank screen (aluminum foil).
4. By directing radiant heating tubing.
5. Produced cement screed.
On top of stacked sections of cable and the sensor is placed concrete screed thickness of 3-5cm. Concrete should not contain sharp objects, and its consistency must be fully fill the cable without the formation of air pockets.
6. Laid flooring (tile, laminate, etc.).
After solidification of the solution is placed decorative flooring (tile, laminate, carpet, etc.). Mounted Honeywell thermostat. According to the accompanying instructions, the necessary wiring connections.
